SPAD.neXt Wiki

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.
====== DirectOutput Service reinstall ======

**Attention: The DirectOutput Service is no longer needed in SPAD.neXt Version 0.9.2.0 (or later)! \\
You can uninstall the DirectOutput Service.**

   - Shutdown your computer. (Important: Not hibernate or sleep mode. Completely shutdown)
   - Disconnect **ALL** FIP and do **not** reconnect them
   - Start computer
   - Uninstall "Saitek DirectOutput (version number)" (From Control panel->Add remove programs (!!! important!!)
   - Reboot Computer
   - Go to C:\Program Files\Saitek
   - Delete the folder Directoutput
   - Reboot computer
   - Check 6. make sure the folder Directoutput is gone
   - Install Directoutput ( download fresh copy! [[ftp://ftp.saitek.com/pub/software/full/FIP/Pro_Flight_Instrument_Panel_7_0_47_1_x64_Drivers.exe]]) and follow the instruction exactly! Do **NOT** (!!!) replug the FIP into the computer before the installer asks you to do so!
   - Reboot computer
   - Check in Control Panel->Administration->Services that the service ''Saitek DirectOutput'' is up and running. (All FIP should show the default slideshow now)
   - Select the ''Saitek DirectOutput'' Service , Right-Click -> Properties, select "Recovery" Tab and change all options to "Restart service".
   - If you want SPAD.neXt to control the service (Start it when SPAD.neXt starts, and shut it down when SPAD.neXt exits) set the startup method to "manual" in the first tab. This however requires that you run SPAD.neXt as Administrator!. Leave it as "automatic" if SPAD.neXt shows a warning that it could not control the DirectOutput Services.
   - Start SPAD.neXt

**Saitek DirectOutput Services have a common known problem with hibernate/sleep mode!** If you are using hibernate mode please shutdown the services before hibernating and restart them when coming back from sleep mode.
It is strongly recommended to completely shutdown your Simulator computer instead of hibernating.

It's a known Problem that DirectOutput Service does not recognize all FIP Devices from time to time, in this case restarting the DirectOutput Service ( Control Panel->Administration->Services->''Saitek DirectOutput'') will help ( restart SPAD.neXt as well).
SPAD.neXt Wiki

User Tools

Site Tools

Page Tools
