VoiceAttack >= 1.5.12.25 (Beta) required!

• Quit VoiceAttack
• In <VoiceAttackInstallDir>\Apps create a directory “SPAD.neXt”
• Copy “GamePlugins\Voiceattack\snVoiceAttack_plugin.dll” to that Directory

For the plugin to work you will need to enable Apps in VoiceAttack.

VoiceAttack and SPAD.neXt need to run on the same computer.

The plugin will use the variables snSTATUS (“OK” or “ERROR”) to signal if the call was successful.
if snSTATUS is “ERROR” the variable snMESSAGE will contain the error message.

Always set the checkbox at “Wait for plugin function to finish”!

using the boolean-variable snDEBUG you can toggle debug output of the plugin on and off.

Available “context” values for VoiceAttack:

Retrieve a variable Value from SPAD.neXt.
Input:
decimal VariableName to contain the full variable name from SPAD.neXt (e.g. LOCAL!SYSTEM READY). Given in decimalVariables
Important: all : (colon) need to be replaced by ! (exclamation mark) due to a limitation of VoiceAttack

Output:
The variable named like the value you queried (e.g. LOCAL!SYSTEM READY) will contain the variable value.
Important: all : (colon) will be replaced by ! (exclamation mark) due to a limitation of VoiceAttack

Set a variable value within SPAD.neXt

Input:
decimal variableName (e.g. LOCAL!SYSTEM READY) needs to contain the new value
Important: all : (colon) need to be replaced by ! (exclamation mark) due to a limitation of VoiceAttack

Execute an event within SPAD.neXt

Following textvariables need to filled and passed to the call:

snDevice must contain the target device (e.g. '06A3:0D06:0' for the first Multi-Panel in system
snSwitch must contain the name of the switch the event shall be executed on (e.g. 'MULTIPANEL_BUTTON_AP' for the Autopilot button
snEvent must contain the name of the event to execute (e.g. 'VALUEON' to emulate a short press )
snParameter must contain the parameter needed by the event , if any

To get an overview of the Devices/Swtches/Events available on you system, in SPAD.neXt navigate to Settings→Application→Expert and press the little gear next to the “Remote Service”-Setting. It will generate a PDF-Document for your system.

You can preview a sample of this document here: devicedocsample.pdf

spad_demo_profile-profile.zip

For your reference the source code of the plugin is available at GitHub SPAD.neXt Public Code